Call us: 772-563-0774

2004 Sopwith Pup Replica * $159,000 USD * Trades Possible, Export Specialist

Meticulously built by Steve Culp, this masterpiece replica of a WWI fighter, built with modern building techniques and 360 HP powerplant is more than beautiful aircraft, it performs better than most modern aerobatic aircraft, stressed to 10 G + o r – it was built to perform on the airshow circuit.  It would cost $500,000 to build this plane today with more than 4500 man hours invested, this is an opportunity of a lifetime to own and fly this beautiful biplane. Call today for further details.

This was an Oshkosh Award Winner.

Registration: N329CC
Serial #1009

Detailed photos of equipment installed on the Sopwith Pup Replica. Also see the Machine Gun available below at an additional cost.

  Andiar fuel valve

Andiar fuel valve

  Mac trim servo located in horizontal stab for pitch trim

Mac trim servo located in horizontal stab for pitch trim

  Trim and Smoke switches located by throttle and prop controls

Trim and Smoke switches located by throttle and prop controls

DSC00535.JPG
  All wood epoxy coated

All wood epoxy coated

DSC00530.JPG
DSC00531.JPG
  Bulkheads full contact with fuselage to keep the compression from fabric from distorting

Bulkheads full contact with fuselage to keep the compression from fabric from distorting

DSC00537.JPG
DSC00538.JPG
DSC00539.JPG
DSC00540.JPG
DSC00544.JPG
DSC00480.JPG
DSC00546.JPG
DSC00485.JPG
DSC00483.JPG
DSC00489.JPG
DSC00494.JPG
DSC00498.JPG
DSC00495.JPG
DSC00497.JPG
DSC00502.JPG
DSC00472.JPG
  Leather upholstery with matching pads on harnesses.   Hooker harnesses in both cockpits.

Leather upholstery with matching pads on harnesses. Hooker harnesses in both cockpits.

  Front cockpit has white main, acrobatic and cheek tanks

Front cockpit has white main, acrobatic and cheek tanks

  Windshields are fastened with adjustable camlocks

Windshields are fastened with adjustable camlocks

DSC00520.JPG

Please note on the wing tip, there is a mount for a Grimes light and the wiring is already run inside the wing.  Just cut the hole in the tip and reach in and grab the wires and wire nuts are inside the predrilled holes for the light mounts.

 Cockpit

Cockpit

  Front cockpit cover.    Center section can be removed for gun and both sides stay in place  .  See gun details below.      

Front cockpit cover.  Center section can be removed for gun and both sides stay in place .  See gun details below.

 

 

 Mount for the Machine Gun

Mount for the Machine Gun

     

 

 

DSC00559.JPG

Maxium machine gun demilled.

For an additional $4500.00 there is a machine gun that was mounted on the Pup and was installed for both Oshkosh trips and airshows.

Mount for gun bolts through bushings in longerons and mount in front of passenger cockpit behind main fuel tank.

15 minute installation.

DSC00556.JPG
  Barrel Clamp

Barrel Clamp

  Barrel Clamp on fuselage

Barrel Clamp on fuselage

  Bushings in Longerons for Gun Mount

Bushings in Longerons for Gun Mount

 Front Machine Gun Mount

Front Machine Gun Mount

  Front cockpit cover with windshield install or with machine gun installed

Front cockpit cover with windshield install or with machine gun installed

  Rear cockpit cover with windshield installed

Rear cockpit cover with windshield installed

Airframe:

TTAF: 128 hours

Engine:

M14P TTSN: 128 hrs

Propeller:

MT 3 Blade:  TTSN 128 hrs

Avionics/Radios:

Garmin GPS, Flight Controls in Front and Rear, Mode C Transponder, Radio/Intercom

Additional Features:

Smoke System: 13 gallons - Inverted Oil and Fuel
Built for Airshow work, rated to 10 G with Light, Responsive Controls

Maintenance/Condition:

No Damage History
Climbs like the Proverbial Homesick Angel

 

 

 

 

All Specifications and Claims subject to Buyer's verification.
Availability subject to prior sale and/or withdrawal from market without notice.


Free Loan Calculator from AOPA

Back to Inventory

Back to the Top